1592025050 iProChill v2.5 10D00 AG v1.3 GB 18.02.2016.docx iProCHILL 6/205
1. IMPORTANT RECOMMENDATIONS
The symbol alerts the user of non-insulated “dangerous voltage” within the product
area that is sufficiently high to constitute a risk of electric shock to persons.
The symbol alerts the user of important operating and maintenance (assistance)
instructions found in the documentation attached to the device.
Dixell Srl cannot accept any liability for damages caused by modems that are not supported.
Dixell Srl reserves the right to modify this manual without prior notice. The documentation can
be downloaded from www.dixell.com even prior to purchase.
This manual forms part of the product and must always be kept near the device for easy and
quick reference. The device cannot be used as a safety device. Verify the limits of application
before using the device.
Verify that the power supply voltage is correct before connecting the device. Do not expose it to
water or humidity: use the controller only within the operating limits, avoiding sudden changes
in temperature and high atmospheric humidity in order to prevent condensation from forming.
Recommendation: disconnect all the electric connections before performing any maintenance.
Insert the probe where it cannot be reached by the End User. The device must not be opened.
Consider the maximum current that can be applied to each relay. Make sure that the wires for
the probes, the loads and the electrical power supply are separated and sufficiently distant from
each other, without crossing or intertwining with each other. In the case of applications in
industrial environments, it may be useful to use the main filters (our mod. FT1) in parallel to the
inductive loads.
The customer shall bear full responsibility and risk for product configuration in order to achieve
the results pertaining to installation and/or final equipment/system. Upon the customer's
request and following a specific agreement, Dixell s.r.l. may be present during the start-up of
the final machine/application, as a consultant, however, under no circumstances can the
company be held responsible for the correct operation of the final equipment/system.
Since Dixell products form part of a very high level of technology, a
qualification/configuration/programming/commissioning stage is required to use them as best
as possible. Otherwise, these products may malfunction and Dixell cannot be held responsible.
The product must not be used in any way that differs from that stipulated in the documentation.
The device must always be inserted inside an electrical panel that can only be accessed by
authorised personnel. For safety purposes, the keyboard must be the only part that can be
reached.
The device must never be hand-held while being used.
To Next Page
Loading...
Need help?
General
