1592025050 iProChill v2.5 10D00 AG v1.3 GB 18.02.2016.docx iProCHILL 35/205
And user can change a parameter’s protecting level to Pr1 or Pr2 in this screen.
Use the UP and DOWN cursors to select the family of parameters and press ENTER.
To modify a parameter, position the cursor on the value and use the UP and DOWN cursors and press SET:
The element starts to flash.
Increase or decrease the value using the UP and DOWN keys.
Confirm the modification by pressing the SET key again.
The cursor will automatically position itself on the next element, to modify it repeat the operation just
described.
When cursor position in different parameters, the parameter’s description will display in the bottom.
Press the ESC key several times to go back to the main screen.
Warning:
For parameter groups CF, IO, CA, and RA, they can be verified and changed only if the unit is switch-OFF
(stand-by).
To Next Page
Loading...
