Emerson Dixell XB570L - How to Modify the Room Set Point

1592006207 XB570L GB r1.1 23.03.2015 XB570L 4/20
PHASE DISPLAY: pushing the UP
key
the running phase is displayed.
PH1= phase 1
PH2= phase 2
PH3= phase 3
HOW TO DISPLAY THE
REGULATION SET POINTS
By pushing the SET key the following
information are displayed in sequenze:
- rSI = Room set point
- iSI = Stop phase set point, referred to
the insert probe
- Back to the room temperature.
HOW TO MODIFY THE ROOM SET
POINT
While rSI or iSI
are displayed hold
pushed the SET key till the rSi or iSi
label starti flashing and LED near the
SET key is turned on.
Use the arrow key to modify the value
and the SET key to confirm it.
8.4 KEYBOARD WHEN THE HOLDING CYCLE IS RUNNING (H)
HOW TO DISPLAY THE HOLDING
(REGULATION) SET POINT
While the holding cycle is running, (H
icon lighted), push the SET key and
the holding set point is displayed on
the UPPER display while the
SETH
label on the bottom display
HOW TO MODIFY THE ROOM SET
POINT
While SETH is displayed hold pushed
the SET key till the SETH label starts
flashing and LED near the SET key is
turned on..
Use the arrow key to modify the value
and the SET key to confirm it.
TO CONFIRM AND EXIT:
push again
the SET key