EasyManua.ls Logo

Emerson EWC19T5 - C Playback; Normal Playback; Tracking Adjustment; Slow Motion

Emerson EWC19T5
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 23 - EN- 23 - EN
PLAYBACK
NORMAL PLAYBACK
Make sure ...
The unit must be turned on.
1 Insert a prerecorded tape
If the erase-prevention tab has been removed, the
unit will start playback automatically.
2 To begin playback
Hit [PLAY O].
3 To stop playback
Hit [STOP C].
NOTES:
Even in the DVD mode, you can start the VCR
playback if you hit [
B
PLAY] (of the TV/VCR
side).
VCR playback will stop and the mode will change
to the DVD mode by pressing [SELECT],
[
B
PLAY] (DVD side) or [
A
OPEN/CLOSE].
TV/VCR
TRACKING ADJUSTMENT
Tracking adjustment will be set automatically
(Digital Tracking function) when you start play-
back.
Noise lines (black and white streaks) may appear
on the playback picture when playing pre-recorded
tapes or tapes recorded on other VCR. If this
occurs, press
[CH. K / L] until the streaks disap-
pear.
You can reduce the noise lines by pressing
[CH. K / L] in the slow mode too. Tracking adjust-
ment in the slow mode will not be set automatically.
To return to the Digital Auto Tracking function,
stop the tape once and start playback.
TV/VCR
PLAY
B
STOP
STILL PICTURE
You can view a still picture on the TV screen during
playback (the still mode). Hit [PAUSE F] during
playback. Only tapes recorded in the SLP mode will
show the least amount of lines. Hit [PLAY O] to
return to playback.
NOTES:
You can advance the picture one frame at a time by
hitting [PAUSE F] during the still mode.
If it is left in the pause mode for more than 5 min-
utes, the unit will automatically switch to the stop
mode.
TV/VCR
SLOW MOTION
Hit [PAUSE F], then hit [D] to start the playback
in slow motion. The unit mutes the sound during
slow motion. Hit [PLAY O] to return to normal
playback.
NOTE:
If it is left in the slow mode for more than 5 min-
utes, the unit will automatically go into the stop
mode.
TV/VCR
VERTICAL HOLD CONTROL
In the pause/still mode only, when the picture begins
to vibrate vertically, stabilize the picture by pressing
[CH. K / L].
NOTE:
If there are video noise lines on the screen, refer to
TRACKING ADJUSTMENT on this page.
TV/VCR

Table of Contents

Related product manuals