Emerson MWI1212SS - Operation; Power Level Selection

EN
13
1. SETTING THE CLOCK
The display lights up when plugged in power supply, it enters standby mode
and shows 1:00.
In standby mode, press the “CLOCK/0” button to enter clock setting mode.
Press the “0~9” number buttons to input the clock time directly. It is a 12-hour
clock, the input is valid only when set between 1:00~12:59.
•
Once the four digits are entered, the clock’s digits stop flashing and
the selected time is saved. If the “START” button is pressed after the
four digits are saved, the microwave oven starts cooking for 30
seconds.
•
If only three digits are entered, you need to press the “START/+30s”
button to save the time set and resume to standby mode.
2. POWER
There are ten microwave power levels, 100P, 90P, 80P, 70P, 60P, 50P, 40P,
30P, 20P and 10P, respectively. Press the “Power” button repeatedly and
select the desired microwave power, or press “0~9” number buttons to select
the desired microwave power. Press the “1” button for 10P microwave power,
press the “2” button for 20P microwave power, and in the case of 10P, press
the “0” button to select 100P microwave power. Press the "TIME COOK"
button to enter the cooking time input mode, and then press “0~9” number
buttons to enter the time, the maximum time that can be input is 99:99. After
entering the cooking time, press “START/+30s” button to start cooking. A
buzzing sound goes off to notify completion of the operation. The display
flashes ‘End’, and keeps flashing till you press STOP or the door is open.
High
Power
100% and 90% power output (Applicable for quick and
thorough cooking)
Medium
High
Power
80% and 70% power output (Applicable for medium express
cooking)
Medium
Power
60% and 50% power output (Applicable for steaming food)
Medium
Low
Power
40% and 30% power output (Applicable for defrosting food)
Low
Power
20% and 10% power output (Applicable for keeping warm)
OPERATION