Emerson Network Power User Manual

Submittal for SiteI/O 10/0E
Liebert Corporation Page 1 of 4 Rev. 4; 10/03
DESCRIPTION: The SiteI/O 10/0E is part of the SiteI/O-Line and is intended to be used with
SiteScan Web systems specifically. It is a 32 bit microprocessor-based device designed to monitor up to
ten thermistors, and/or dry contact type signals. Logically the device, sits on the Ethernet network,
providing the interface to SiteScan Web. This effectively creates a device that is a router / gateway and
I/O module in one device. Screw terminal blocks are provided to terminate power, communication, and
input signal wiring.
DIMENSIONS: Module: 7 1/8" H x 6 1/4" W X 1 5/8” D
18.10cm H x 15.88cm W X 4.13cm D
Enclosure: 12”H x 14.25" W x 2.85" D
(painted steel) 419.1mm x 301.3mm x 78.6mm
POWER: 24 VAC ±10%, 50-60 Hz, 7.2 VA.
ENVIRONMENTAL
OPERATING RANGE:0 to 130°F (-17.8 to 54.4°C); 10 to 90% relative humidity, non-condensing.
For UUKL Smoke Control Systems, 32°-120.2°F (0°-49°C); 10 to 85% relative
humidity, non-condensing.
COMMUNICATIONS: One (1) Ethernet 10BaseT RJ-45 port
MEMORY: 1 MB flash, 1 MB RAM.
BATTERY: Seven-year lithium battery provides a minimum of 10,000 hours of data retention
during power outages.
FAULT DETECTION:Hardware watchdog timer.
PROTECTION: Built-in surge and transient protection circuitry.

Emerson Network Power Specifications

General

Brand	Emerson
Model	Network Power
Category	Network Card
Language	English

Summary

Product Specifications

Product Description

Overview of the Sitel/O 10/0E as a router/gateway and I/O module for SiteScan Web.

Module Dimensions

Physical dimensions of the Sitel/O 10/0E module, including height, width, and depth in inches and cm.

Power Requirements

Specifies the required power input voltage and frequency, and apparent power consumption.

Environmental Operating Range

Details the acceptable ambient temperature and humidity ranges for device operation.

Communications Interface

Identifies the type and connector for network communication, typically Ethernet.

Memory Specifications

Details the available flash and RAM memory capacities for the device.

Battery Backup

Describes the seven-year lithium battery for data retention during power outages.

Fault Detection

Highlights the hardware watchdog timer used for fault detection and system reliability.

Protection Circuitry

Notes the inclusion of built-in surge and transient protection circuitry for durability.

Module Layout and Wiring

Module Dimensions and Layout

Diagram illustrating the physical layout of the Sitel/O 10/0E module, showing ports and components.

Power Wiring Diagrams

Illustrations of different power wiring configurations for the device, including grounding methods.

Enclosure Dimensions and Mounting

Enclosure Dimensions

Detailed measurements and diagrams of the protective enclosure for the Sitel/O 10/0E.

Enclosure Wall Mounting

Diagrams showing the specifications and hole placements for mounting the enclosure on a wall.

Enclosure Floor Mounting

Diagrams detailing the dimensions and methods for placing the enclosure on the floor.