Parameter 02.032 Acceleration Rate Select Bit 0
Short description Defines which acceleration rate is used if acceleration rate selector = 0
Mode Open‑Loop
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate 4ms read
Display Format Standard Decimal Places 0
Coding RW, NC
See Acceleration Rate Selector (02.010).
Parameter 02.033 Acceleration Rate Select Bit 1
Short description Defines which acceleration rate is used if acceleration rate selector = 0
Mode Open‑Loop
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate 4ms read
Display Format Standard Decimal Places 0
Coding RW, NC
See Acceleration Rate Selector (02.010).
Parameter 02.034 Acceleration Rate Select Bit 2
Short description Defines which acceleration rate is used if acceleration rate selector = 0
Mode Open‑Loop
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate 4ms read
Display Format Standard Decimal Places 0
Coding RW, NC
See Acceleration Rate Selector (02.010).
Parameter 02.035 Deceleration Rate Select Bit 0
Short description Defines which deceleration rate is used if deceleration rate selector = 0
Mode Open‑Loop
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate 4ms read
Display Format Standard Decimal Places 0
Coding RW, NC
See Deceleration Rate Selector (02.020).
Parameter 02.036 Deceleration Rate Select Bit 1
Short description Defines which deceleration rate is used if deceleration rate selector = 0
Mode Open‑Loop
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate 4ms read
Display Format Standard Decimal Places 0
Coding RW, NC
See Deceleration Rate Selector (02.020).
Parameter 02.037 Deceleration Rate Select Bit 2
Short description Defines which deceleration rate is used if deceleration rate selector = 0
Mode Open‑Loop
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate 4ms read
Display Format Standard Decimal Places 0
Coding RW, NC
See Deceleration Rate Selector (02.020).
To Next Page
Loading...
