Parameter Default Drive modes Drive voltage rating
Maximum reference clamp (01.006) 60.0Hz Open-loop All
Maximum reference clamp (01.006) 1800rpm RFC-A All
Standard Ramp Voltage (02.008) 775V Open-loop, RFC-A, RFC-S 400V
Rated Frequency (05.006) 60.0Hz Open-loop, RFC-A All
Rated Load rpm (05.008) 1800rpm Open-loop All
Rated Load rpm (05.008) 1770rpm RFC-A All
Rated Voltage (05.009) 460V Open-loop, RFC-A, RFC-S 400V
M2 Maximum Reference Clamp (21.001) 60.0Hz Open-loop All
M2 Maximum Reference Clamp (21.001) 1800rpm RFC-A All
M2 Rated Frequency (21.006) 60.0Hz Open-loop, RFC-A All
M2 Rated Load rpm (21.008) 1800rpm Open-loop All
M2 Rated Load rpm (21.008) 1770rpm RFC-A All
M2 Rated Voltage (21.009) 460V Open-loop, RFC-A, RFC-S All
Non-volatile media card data transfer
Details of the data that can be stored on a non-volatile media card and the methods to transfer/access this data are given in Menu 11.
Stored HF trips
When the drive is subsequently powered up a Stored HF trip is initiated where the sub-trip number is the number of the HF trip that last occurred. This
trip will occur at every power-up until it is reset. The trip can only be reset by first entering 1299 into Parameter mm.000 (mm.000). If the drive is
powered up and a Stored HF trip occurs, Onboard User Program: Enable (Pr 11.047) is reset to zero to prevent the on-board user program from
running. This ensures that the user program can be changed or erased in case it causes an HF trip at every power-up. Once the Stored HF is cleared, it
is necessary to power cycle the drive or to re-download the user program to allow the program to restart.
To Next Page
Loading...
