Support for the T-60’s 8 bit I/O has been provided by the following
commands. Some commands refer to 24 bits of I/O instead of 8. This reflects
the compatability between the T-60 and the T-61 (the T-61 has 24 bits of I/O
standard while the T-60 has 8 bits of I/O). The T-60 can only use the lower 8
bits of these commands.
INP Input port data
IO24 Specify an I/O bit pattern to generate an interrupt.
ON IO24 Interrupt on an I/O bit pattern
OUT Output port data
These commands are described in the EMERSON EMC BASIC USERS
GUIDE in a manner which works with both the EMERSON EMC T-61 and
T-60. The specific changes are as follows:
INP Input range of 0 to 255.
IO24 Bit pattern ranges: “0”, “1” or “X” through “00000000”,
“11111111”, or “XXXXXXXX”. the input may still be a
string variable.
ON IO24 Unchanged.
OUT Output range 2 to 255. The MAP function works over
the range of: “0”, “1” or “X” through “00000000”,
“11111111”, or “XXXXXXXX”.
There are similar restrictions on the use of the EVENT DRIVEN SOFTWARE.
I/O ranges are limited to 8 bits. If you have questions about the EVENT DRIVEN
SOFTWARE and the T-60, please contact EMERSON EMC.
Figure 9
One Channel of the 8 Bit I/O
T-60 Operator's Manual
12
To Next Page
Loading...