cmd specifies the type of PLC protocol that you are initiating. This can vary
depending upon PLC manufacturer, and possibly model, according to the
following table:
Examples:
10 CALL PLCINIT(1,1)
Establishes communication with a Modbus, GE Series 90, PLC-5, SLC-500,
Omron Hostlink, or TI505 PLC (depending on the installed interface option)
with an ID (address) of 1.
10 CALL PLCINIT(1,435)
Establishes communication with a TI435 PLC with an ID (address) of 1
(when the -TI3 option is installed).
10 CALL PLCINIT(1,2)
Establishes communication with a Modicon, AB PLC-5, or SLC-500 with an
ID (address) of 1 on COM 2.
T-60 Operator's Manual
62
To Next Page
Loading...