9
6. The additional cursor eld displays the operating states for
the meter. The arrows indicate whether any manipulation or an
installation error was registered or if the power threshold was
exceeded.
MAN
The cursor is active where any manipulation of the terminal
cover, meter cover or any magnetic inuence is registered.
PWR1 The cursor is active if the rst dened power threshold in
the meter was exceeded.
PWR2
The cursor is active if the second dened power threshold
in the meter was exceeded.
7. The standard cursor eld displays the operating states for the
meter. The arrows indicate which tari and maximum meter are
active, and how the meter is being controlled (clock or ripple control
receiver).
T1 - T4
Tari information for energy. All activatable tari indexes
are denoted on the name plate.
M1 - M4
Tari information for power. All activatable power indexes
are denoted on the name plate.
TST The cursor is displayed if test mode is activated.
RL The cursor ashes on and o as long as a resetting
lock is active.
CLOCK The cursor is active when the internal device clock
actuates the tari meter.
SET The cursor is active when the meter is in the Set mode.
8. The value area displays the measured values.
9. The code area denes the measured values according to the OBIS
key. The display can show all six value groups.
To Next Page
Loading...
Need help?
General
