4
Ref Preset value set according to weld program.
+ tol Positive tolerance. "0" selections will not be monitored.
- tol Negative tolerance. "0" selections will not be monitored.
Act Actually measured weld parameters of last weld.
Vp [V]
Arc voltage in pilot current phase. *
Vw [V] Arc voltage in weld current phase.
Iw [A] Weld current.
tw [ms] Weld time.
td [ms] Stud drop time.
Lift [mm] Lift distance.
An exclamation mark before the text Lift signifies that the
stud length measurement function for SD2 has been
deactivated in terms of position.
* Some voltage values are of particular importance (see Annex E).
Fault The fault will be displayed that has occured during welding.
Possible fault indications are:
None Weld cycle without fault.
SMPS Defect within SMPS, welding was stopped.
Lift Cycle On Fault when enabling the solenoid.
No arc Voltage Defective lift; short circuit in weld circuit.
Short circuit weld The last weld performed was a short circuit operation.
Lift Cycle Off Fault when disabling the solenoid.
Drop Time
Timeout
Monitoring time in weld sequence was exceeded.
No Weld Current The last weld performed was an open circuit operation.
Faults will be recorded under a fault number in the fault memory.
Selecting the function keys .. will open the corresponding sub-menu. By
pressing or you will access the main menu.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
