Eminent CamLine Pro - 2 How to Access the Camera Again after the Update Using the App; How to Change the Default Password Using the App; Re-Program the UID of the Camera

4 | ENGLISH
update.
• When the update is successful, the CamLine Pro IP camera will automatically
reboot.
Please note: Do not power off the camera during the upgrade procedure. The
firmware update process can take up to 10 minutes.
Please note: After updating the firmware the settings of the camera will be reset to the
factory default settings incl. the WiFi settings. The password of the camera is changed
to “ipcam” instead of the password mentioned on the ID card or bottom label of the IP
camera.
1.5 Re-program the UID of the camera.
• After the update is done, close the web browser and go back to the Migration tool.
• Paste the UID copied from chapter 1.3 back into the UID field.
• Press “Set new ID”.
• A pop-up will be displayed to enter account and password. By default this is
“admin” and the password of the camera “ipcam”
• Now press “OK”.
• A second pop-up will be displayed notifying “Set OK” now press “OK”.
• For the UID to be applied the camera needs to be rebooted press “Reboot”.
• A pop-up will be displayed press “OK”.
• A pop-up will be displayed to enter account and password. By default this is
“admin” and the password of the camera “ipcam”
• Now press “OK”.
• And press again “OK”.
2.0 How to access the camera again after the
update using the app:
• Open the CamLine Pro app.
• Press in the camera window you’ve just updated.
• Press .
• Change the password to: ipcam.
• Press the “back” arrow.
2.1 How to change the default password using the app:
• Open the CamLine Pro app.
• Press in the camera window you’ve just updated.
• Press .