5 |
ENGLISH
4.2 Configuring the EM4218 for a connection to the
Internet
To configure the EM4218 for a connection to the Internet, you first need to connect to
the EM4218. You can connect to the EM4218 using the following procedure:
1. Turn on your computer.
2. Open your Internet browser (for instance Internet Explorer, Netscape or Firefox).
3. Enter ‘http://192.168.1.1’ in the address bar.
4. Press Enter or click ‘Go to’.
5. Enter ‘admin’ in the ‘User Name’ field (Note! This field is case sensitive).
6. Enter ‘admin’ in the ‘Password’ field (Note! This field is case sensitive).
7. Click ‘Log in’.
8. The opening page is shown.
4.3 Configuration for PPP providers
1. Click ‘Setup Wizard’.
2. Select the country where you live in the ‘Country’ field (For instance
‘Netherlands).
3. Select your Internet provider in the ‘ISP’ field.
4. Click ‘Next’.
5. Enter your ADSL username in the ‘Username’ field.
Have I got a proper network connection? Turn on the computer and verify if the light –
corresponding with the LAN-port on which you connected the UTP networking cable –
is lit. On the network adapter in your computer a light should be lit as well.
Hint! To prevent unauthorised people gaining access to your EM4218 it is
recommended to change your password.
1. Click ‘Tools’.
2. Click ‘Password’.
3. Choose ‘admin’ in the ‘Username’ field.
4. Enter the current password in the ‘Old Password' field.
5. Enter the new password in the ‘New Password' field.
6. Enter the new password again in the ‘Confirmed Password’ field.
7. Click 'Submit'.
8. Click ‘Ok’.
Write down the new password to be able to change settings in the future:
User Name: admin
Password: _________________________________________________
To Next Page
Loading...