7 |
ENGLISH
5.1 WPA2 security (recommended)
1. Select ‘WPA2 (AES)’ in the ‘Encryption’ field.
2. Select ‘Personal (Pre-Shared Key)’ in the ‘WPA Authentication Mode’ field.
3. Select ‘Passphrase’ in the ‘Pre-Shared Key Format’ field.
4. Enter a password in the ‘Pre-Shared Key’ field. For instance ‘yourname01’. Do
not use any peripherals and make sure the password is at least 8 characters
long!
5. Write down the chosen password*.
6. Click ‘Submit’.
7. Click ‘Save’ (upper right corner) to save the settings.
5.2 WEP security
1. Select ‘WEP’ in the ‘Encryption’ field.
2. Click ‘Set WEP Key’.
3. A new screen will appear.
4. Select 64 or 128 bit in the ‘Key Length’ field.
5. Select ‘ASCII’ or ‘Hex’ in the ‘Key Format’ field.
6. Select ‘Key 1’ in the ‘Default Tx Key’ field.
7. Enter a password in the ‘Encryption Key 1’ field. Do not use any peripherals and
make sure the password is exactly 5, 10, 13 or 26 characters long, depending on
the other key settings.
8. Write down the chosen password *.
9. Click ‘Submit’.
10. Click ‘Save’ (upper right corner) to save the settings.
6.0 Control your Internet connection
If you want to expand the security of your wireless network you can set MAC Address
Control on your EM4218. This MAC address is a unique code attached to each and
every network device. MAC Address Control enables you to allow specified network
WPA security is supported by Windows 2000 and newer Windows versions. This
security method is not supported by Windows 98 or ME! If you have Windows 98 or
ME, then continue with section 5.2.
The connection is lost when the security (WPA, WPA2 or WEP) has been enabled in
the EM4218 and not yet in the wireless network adapter. As soon as the security
settings are set in the wireless network adapter, the connection will be repaired.
*Write down the security method you used and the password:
WPA
WPA2
WEP
Password: ______________________________________________________
To Next Page
Loading...