Need help?Do you have a question about the emitor SATLOOK Mark III DiSEqC and is the answer not in the manual?
General| Frequency Range | 950-2150 MHz |
|---|---|
| Impedance | 75 Ohm |
| DiSEqC Compatibility | Yes |
| Display | LCD |
| Input Level | -65 ~ -25dBm |
| Battery Life | Approx. 2 hours |
Start with unpacking the instrument and check that the following items are in the cardboard box.
Check the battery condition before transportation and recharging.
Connect coaxial-cable and LNB preferably when the instrument is turned off.
Switch between Picture, Spectrum, and Expanded Spectrum for signal analysis.
Adjust frequency, display signal strength, use offset and beeper.
Control LNB polarity (13/18v) and frequency bands (I/II, 22 KHz).
Operate DiSEqC accessories like switches and LNBs.
Manage audio settings and check battery condition.
To Next Page
