13
the harness strip on the rearside of the seat (see
5 point harness FLAT+).
5.2 Adjust the footrest down by pulling the plastic
handle on the frontside of the footrest with one
hand. To adjust it up, lift it up into position.
Note: Maximum weight on the footrest is 3kg.
5.3 Adjust the headrest by pulling the textile handle
on top of the headrest upwards while carefully
adjusting the headrest upwards or downwards.
The correct position of the headrest is in the
same height as the head or the child. The
harness need to come out directly above the
shoulders of the child.
WARNING
• Ensure that children are kept away from all
moving parts of the pram to avoid risk of injury.
• Ensure that children are kept away while adjusting
the headrest.
• Always check that the seat unit is in one of the
positions by pushing it back until it locks into
place.
• Never let the child/children stand on the footrest.
• Always make sure the harness is pulled tight after
adjustment.
6) Removal of the seat unit fabric
6.1 Open the clips on both sides of the hood and
remove the hood from the seat unit.
6.2 Open the press studs on the seat unit and on
the footrest (press studs in total: 3 x armrest left,
3 x armest right, 5 x backrest front, 9 x backrest
rearside)
6.3 Thread the harness straps through the holes in
the fabric.
6.4 Thread the crotch strap from the fabric and
remove the fabric from the seat unit inclusive the
fabric on the headrest.
5-point harness (FLAT+)
1) 5-point harness FLAT+ - Buckle the Child
1.1 Adjust the headrest into the position so that
the shoulder straps are in level with your child’s
shoulders. The height of the shoulder straps and
the head cushion can be adjusted by pulling
the release handle upwards at the top of the
headrest and pulling the headrest up or down.
1.2 Make sure that each shoulder harnesses is
correctly clicked together with the clips and
covered by the shoulder pads. The shoulder pads
have to be fastened with a press studs.
1.3 Place the child into the FLAT+ seat unit.
1.4 When the child is positioned, place the shoulder
straps over the child’s shoulders.
1.4 Click the right buckle over the left buckle until
they are held together as a unit
1.5 Close the harness with the harness lock on the
crotch strap with a ”CLICK”
WARNING
Always check that the belt is properly closed by
pulling on it.
1.6 Tighten the harness by pulling the strap on the
back of the backrest.
1.7 Pull the backrest handle upward and hold it to
loosen the harness.
1.8 Open the harness by pressing on the central
lock.
Emergency opening function
• If you need to quickly release the belt you can
press on the central lock.
• You can even open the shoulder straps by
clicking on the clips under the shoulder pads.
WARNING! Loose straps in the safety harness may
pose a risk of strangulation for children. When the
pram is not in use, the shoulder straps must always
be unfastened in the middle of the shoulder bands.
WARNING
• It is important that the seat unit fabric is always
correctly tted
• Never use the stroller without making sure the
seat unit fabric is correctly assembled on the
frame rst.
• The harness straps must always be locked when
the child is in the seat.
• The harness straps must be tightened without
slack and not twisted.
• DO NOT attempt to dismantle, modify or add any
part to the seat.
• Never leave your child unattended.
• Make sure all users are informed about how to
release your child in case of emergency.
To Next Page
Loading...
