22 23
Location & Instructions
11. CIRCUIT BREAKER
Step 5: Follow the marking on the circuit
breaker, switch the circuit breaker o.
Step 6: Before you want to charge the bike/
use the bike, switch the circuit breaker on.
Step 8: Gently push the seat sushion down to
lock it.
Step 7: When putting the seat back, make sure
the teeth on the bottom of the seat (highlighted in
red) are inserted into the holes.
Warning:
• The wires inserted into circuit breaker could have high voltage output.
DO NOT touch any bare wires. If you have any concern, contact your
EMMO dealer for assistance.
To Next Page
Loading...
