Emos E6016 - Alarm Settings; Unit Settings

7
Alarm Settings
2 alarms can be set on the weather station.
1. Short-press the button twice
2. Press the
button for 3 seconds and use the arrows to set the alarm hour and minute.
3. Conrm the set value by pressing
; holding the arrow keys speeds up settings.
Alarm Activation/Deactivation/Snooze
Repeatedly pressing the button activates alarm 1 (AL1); alarm 2 (AL2); or both alarms at the same
time (AL1, AL2); or deactivates the alarms.
You can postpone (snooze) the alarm by 5 minutes by pressing the
button. After pressing, the
icons will start ashing.
Turn o the alarm by pressing
. After pressing, the icons will stop ashing
and only
will remain on the screen. The alarm will activate again the next day.
Setting Altitude and Atmospheric Pressure
The station shows atmospheric pressure in hPa or inHg and keeps a history of pressure readings
for the last 12 hours.
To achieve more accurate calculation of pressure values, it is advised to manually set the altitude
for the place where the weather station is being used.
1. Short-press the button three times
2. Press the button for 3 seconds and use the arrows to set altitude between -90 m to +1,990
m (10 m increments).
3. Pressing the button switches between M/hpa and Ft/inHg units.
4. Short-press the button to quit settings.
Setting Unit of Precipitation
1. Press the button ve times, then press the button for 3 seconds.
2. Use the and arrows to set mm or inches as units.
3. Short-press the button to quit settings.
Setting Unit of Wind Speed
1. Press the button six times, then press the button for 3 seconds.
2. Use the and arrows to set km/h or mph as units.
3. Short-press the button to quit settings.
Setting Temperature Limits for Maximum and Minimum Temperature
Temperature limits can be set independently for up to 3 outdoor temperature sensors.
When minimum or maximum temperature limit is activated, the
(min) or (max) icon will
appear on the screen and disappear after deactivation.
Temperature limit ranges
Outdoor Indoor
Minimum -30°C to +10°C 0°C to 23°C
Maximum 28°C to +60°C 26°C to 50°C
Resolution 0.5°C 0.5°C
While on the main screen, repeatedly press the
button to switch to sensor 1, 2 or 3 and proceed
for each sensor as follows.
1. Short-press the button four times.
2. Press the button for 3 seconds and set the minimum outdoor temperature.
3. Short-press the button and activate (ON)/deactivate (OFF) the outdoor minimum temper-
ature alert.
4. Short-press the button and set the minimum outdoor temperature.
5. Short-press the button and activate (ON)/deactivate (OFF) the outdoor maximum temper-
ature alert.