Emos P5822 - Maintenance and Safety; Data Deletion and Battery Replacement; General Safety Precautions

7
Press „ENERGY/+“ or „COST/-“ to select the week you want to show. -1 indicates last
week, -2 two weeks ago etc. up to -7 seven weeks ago. The real power consumption is
shown on the second line.
6.3 Actual power consumption in the last 7 months:
Hold the „HISTORY“ button for 3 seconds once screen shows the „monthly“ value.
Press „ENERGY/+“ or „COST/-“ to select the month you want to show. -1 indicates last
month, -2 two months ago etc. up to -7 seven months ago. The real power consumption
is shown on the second line.
7. Quickly deleting data
7.1 Press and hold „ENERGY/+“ and „COST/-“ simultaneously for 3 seconds, until the
screen starts blinking.
7.2 Then press and hold „SET/OK“ for 3 seconds. All the data will be erased.
8. Replacing batteries
8.1 Open the battery compartment cover on the back side of the consumption metre.
8.2 Remove the at batteries.
8.3 Insert new 2× 1.5 V (LR44/AG13) batteries. Make sure you observe the correct polarity.
Use alkaline batteries only, not rechargeable ones.
8.4 Close the cover.
Safety warning
• Connect the metre to a230 V~/50 Hz (±10 %), max. 16 Anetwork tted with asafety
switch/contact.
• Only appliances powered by 230 V~/50 Hz voltage can be connected to the metre.
• Pay attention to the data on the type label of the appliances connected to the device.
• The maximum input power of the connected appliances must not exceed 3 680 W
(max. current 16 A).
• Use the metre in closed spaces and dry environments only. Using the metre outdoors
is strictly forbidden!