Adjusting the headband
INSIGHT headset
The long arm is referred to as the headband and it is manufactured to fit a wide variety of
head sizes. The arm is angled inwards so that the sensor when fitted is making contact
with the T8 location and not the plastic arm. The headband can be adjusted for users with
bigger heads where the shipped headband is not comfortable. This can be done at home
using a hairdryer. The arm is made from two separate layers of plastic but can be adjusted
by warming the plastic with a hairdryer until it becomes pliable and allows you to slowly
adjust the headband and they both need to be warm or it could separate while adjustment.
Please do not try to bend when cold or the plastic could crack.
This method can be used on any of the arms if you feel they aren't making good contact
onto the head.
To Next Page
Loading...
