Need help?Do you have a question about the EMPHASER EA2160 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Amplifier Class | AB |
| Frequency Response | 10Hz - 30kHz |
| Signal-to-Noise Ratio | > 90 dB |
| RMS Power @ 2 ohms | 2 x 240 Watts |
| RMS Power Bridged @ 4 ohms | 1 x 480 Watts |
| Lowpass Filter | 50 - 250 Hz |
| Highpass Filter | 50Hz - 250Hz |
| Bass Boost | 0dB - 12dB |
| RMS Power @ 4 ohms | 2 x 160 Watts |
| Input Sensitivity | 0.2V - 6V |
Details controls and indicators on the front panel of EA2160/EA2220 models.
Details terminals and connections on the rear panel of EA2160/EA2220 models.
Details controls and indicators on the front panel of the EA480 model.
Details terminals and connections on the rear panel of the EA480 model.
Details controls and indicators on the front panel of the EA450-300 model.
Details terminals and connections on the rear panel of the EA450-300 model.
Instructions for connecting the main power supply wires safely and correctly.
Guidance on routing audio signal (RCA) and remote turn-on wires.
Instructions for connecting loudspeaker wires to the amplifier outputs.
How to choose the correct operation mode (HPF, BPF, FULL) for speaker systems.
Guide to setting the high-pass filter frequency for satellite speakers.
Instructions for setting the low-pass filter frequency for subwoofers.
How to adjust the subsonic high-pass filter for bandpass subwoofer operation.
Steps for setting input gain controls to match head unit output for optimal dynamics.
Details what damages and conditions are not covered by the warranty.
To Next Page
