EasyManua.ls Logo

Empire Comfort Systems WB36FB0F - User Manual

Empire Comfort Systems WB36FB0F
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Page 1
HOMEOWNER'S MANUAL
INSTALLER:
Leave this manual with the appliance.
CONSUMER:
Retain this manual for future reference.
We suggestthat our
wood burning hearth
products be installed
and servicedby
professionals who are
certified in theU.S.by
the National Fireplace
Institute
®
(NFI) as
NFIWood Burning
Specialists.
This replace is approved
for use as a wood burning
replace or for use with a
vented gas log approved
to ANSI Z21.60 or Z21.84
standards or for use with
a vent-free gas log heater
approved to ANSI Z21.11.2
standard.
WARNING
If the information in this manual is not
followed exactly, a re or explosion may
result causing property damage, personal
injury or loss of life.
DO NOT store or use gasoline or other
ammable vapors and liquids in the
vicinity of this or any other appliance.
DO NOT overre. Overring will void
your warranty.
Comply with all minimum clearances to
combustibles as specied. Failure to
comply may cause house re.
WARNING
FIRE RISK! For use with solid wood fuel
only. Other fuels may overre and generate
poisonous gases (i.e. carbon monoxide).
DO NOTNEVERtouch glass until it is cooled. allow
children to touch glass. Keep children away. CAREFULLY
SUPERVISE children in same room as fireplace. Alert
children and adultsto hazards of high temperatures.
High temperatures may igniteclothing or other
ammable materials.Keep clothing, furniture, draperies
and other flammable materials away.
DANGER
CAUSE BURNS.
AND COOL DOWN.
HOT GLASS WILL
HOT SURFACES! GLASS
AND OTHER SURFACES ARE
HOT DURING OPERATION
WOOD BURNING
FIREPLACE MODELS:
WB
(
36,44,54
)
FB0F
WARNING
DO NOT alter or modify the replace or
its components under any circumstances.
Any modication or alteration of the
replace system, including but not limited
to the replace, chimney components
and accessories, may void the warranty,
listings and approvals of this system and
could result in an unsafe and potentially
dangerous installation.

Questions and Answers

  • A
    Angela MuellerAug 12, 2025
    What to do if cold air drafts coming from Empire Comfort Systems Indoor Fireplace?
    • S
      sean32Aug 12, 2025
      If you're experiencing cold air drafts coming from your Empire Comfort Systems Indoor Fireplace, there are a few potential causes. The air might be coming out of the fireplace opening; in this case, close the damper and/or outside air damper. Air could also be coming in around the sides of the fireplace, between the fireplace and the wall; make sure the fireplace frame has been sealed to the wall.
  • Z
    zmillerAug 17, 2025
    How to prevent glass door breakage in Empire Comfort Systems WB36FB0F Indoor Fireplace?
    • A
      Alexander BarnettAug 17, 2025
      To prevent glass door breakage in your Empire Comfort Systems Indoor Fireplace, consider these points: heat should not build up too fast, so before closing the doors, allow them to warm up slowly as you build the fire, and close them once the fire is established and the doors are heated. Also, ensure the fire is an appropriate size by checking the manual for the correct fire size, as continued operation at excessively high temperatures may cause the glass to partially lose its temper and break. Finally, logs and burning material should not touch the glass.
  • H
    Harold ChristensenAug 21, 2025
    How to clean dirty glass doors on Empire Comfort Systems WB36FB0F?
    • P
      Peggy AndersonAug 21, 2025
      To clean dirty glass doors on your Empire Comfort Systems Indoor Fireplace, avoid hard chemical cleaners as these will leave unattractive marks. Instead, simply use a clean cloth covered in water. You can avoid this problem by cleaning it regularly.
  • M
    Michael LaneAug 25, 2025
    What material to burn in Empire Comfort Systems WB36FB0F Indoor Fireplace?
    • Z
      Zoe RussellAug 26, 2025
      Make sure you’re only burning seasoned, dry wood in your Empire Comfort Systems Indoor Fireplace. It is recommended purchasing a moisture meter to check the wood before burning.
  • S
    Sharon SmithAug 29, 2025
    How to improve burning techniques in Empire Comfort Systems WB36FB0F Indoor Fireplace?
    • M
      matthewmartinAug 29, 2025
      To burn wood correctly in your Empire Comfort Systems Indoor Fireplace: 1. Heat your flue and let it reach about 600 degrees. 2. Fill your grate with wood. 3. Wait around 10 minutes. 4. Close the doors of your fireplace and keep the doors closed until you go to load more wood.
  • T
    Theresa MarksSep 2, 2025
    How to improve wood storage for Empire Comfort Systems Indoor Fireplace?
    • R
      robin98Sep 2, 2025
      Store firewood for your Empire Comfort Systems Indoor Fireplace on an elevated rack that is covered, yet slightly elevated, to allow air flow. Store firewood a short distance from your building’s exterior to ensure pests don’t enter your home.
  • S
    sarah44Nov 7, 2025
    Why is my Empire Comfort Systems WB36FB0F smoking?
    • A
      Aaron McdanielNov 7, 2025
      Your Empire Comfort Systems Indoor Fireplace might be smoking due to several reasons. It could be that other appliances are competing for available air; if this is the case, turn off any competing appliance while operating the fireplace, if possible. The grate might be too close to the front of the fireplace; make sure to position the grate on the grate retainer brackets. The damper may not be fully opened; ensure the damper is in the fully opened position. The outside air damper might not be open; ensure the air damper is in the opened position and adjust it until fully open if needed. Operating the fireplace with partially closed doors can also cause smoking; during fireplace operation, doors should be either fully opened or fully closed. A flue and termination caked with creosote buildu...

Empire Comfort Systems WB36FB0F Specifications

General IconGeneral
BrandEmpire Comfort Systems
ModelWB36FB0F
CategoryIndoor Fireplace
LanguageEnglish

Related product manuals