Safety information (continued)
Remove power from the electrical panel before
inspecting. Wear protective eyewear and protective
gloves before attempting to inspect the Vue system.
Ensure no wiring for voltage measurement, current
measurement, power, or data are frayed or have
exposed conductors. Ensure there are no cracks,
breaks, or other defects in the enclosure of the Vue or
CTs.
If you believe any of the Emporia Vue components may
have been damaged, do not attempt to use them.
Contact support at support@emporiaenergy.com
immediately.
Do not use the Emporia Vue in any manner other than
specified in this installation guide, otherwise, the
protection provided by the equipment may be impaired.
Do not attempt to open, disassemble, or repair any of
the components of the Emporia Vue.
Do not install the Emporia Vue in environments with
explosive gas or vapors; nor in damp or wet
environments; nor in direct sunlight; nor where
temperatures are consistently below -40° F (-40° C) or
above 122° F (50° C).
Ensure the Emporia Vue does not have power during
any handling, including installation and disassembly.
Do not perform any maintenance, service, or cleaning
of the Vue after installation. Contact customer service
for support.
The Emporia Vue should only be used with Listed
Energy-Monitoring Current Transformers.
Basic Insulation, use CTs only on insulated conductor,
secured from contacting live parts.
To reduce risk of electric shock, always open or
disconnect circuits from the power-distribution system
(or service) of a building before installing or servicing
current transformers.
The Emporia Vue should be wired to power using
16AWG, 600V, UL1015, 105° C (or higher) copper-only
wires
It is recommended that the Emporia Vue be wired to
the breaker closest to the device.
To Next Page
Loading...
Need help?
General
