©2018 EMS Ltd. All rights reserved. Page 11 of 24 TSD115 Iss2 17/09/2018 AJM
Double click on the output eld. The display will change to show the device’s output properties.
Ensure all elds are un-selected and that a delay is not present.
Also ensure the zone setting for the output (Wireless RIM) corresponds with the zone that is to
cause the device to operate. An example with the correct settings to follow zone 1 operation is
shown below:
Note: the zone setting for the device (Wireless RIM) is only relevant for the cause and eect
when programming the unit to follow the activation of a zone of devices.
1
2
3
4
To Next Page
Loading...