EMS FirePoint 5000 - Page 15

EMS 5000 FIREPOINT
ENGINEERS OPERATING GUIDE, ISSUE 3.0 – 16/08/10
15
11 Press the “0” key and the screen will now
display:
12 Enter the device number that you want to re-
instate (e.g. 125) then press the “YES” key and
screen will now display:
13 Press the “∇” key until the screen displays:
14 Press the “YES” key once the Screen will now
display:
15 Press the “∇” key until the screen displays:
16 Press the “YES” key once the Screen will now
display:
17 Press the “NO” key until the screen displays:
18 Turn the Control key to the “OFF” Position. The
screen will now display:
Note: The “DETECTOR/ZONE DISABLED” LED on the 5000 FirePoint
Master Panel and System 5000 Slave Panel will clear and the Disable beep
will stop.
Enter Device
(Number 1-256)
Number > _
Yes = Finish Time
Time
| Panel : 04 |
> Device : 125 <
| Status :Disable |
Yes= Select Time
| Device : 125 |
> Status :Disable <
| Transmit Event |
Yes= Select Time
| Device : 125 |
> Status : Active <
| Transmit Event |
Yes= Select Time
| Status : Active |
>Transmit Event <
| ^^^^^^^^^^^^^^ |
Yes= Select Time
Device 125 on NET 04
Set to ACTIVE
Push Any Key Time
Panel in Access
Date
Time
Status Normal
Date
Time