To Next PageTo Next Page
Need help?Do you have a question about the EMTEST AN 200 Series and is the answer not in the manual?
Introduction to the AN 200 Series for voltage transient emission testing, referencing ISO 7637 Part 2.
Details the specific devices AN 200 and AN 200B covered by this manual and their standard compliance.
Identifies and describes the front panel controls, indicators, and connectors of the AN 200.
Details Normal, Switch, and Artificial Network operation modes.
Details the rear panel connectors, ventilation, and power switch of the AN 200.
Identifies the three main parts (switch, resistor, network) and describes different network configurations.
Details the electronic switch's function and protection, and the shunt resistor's purpose and values.
Details the artificial network's inductance, RC network, and impedance characteristics as per standards.
Specifies test load configuration and test voltages for measuring switch-off times.
Defines switch-off time measurement criteria and illustrates the test setup block diagram.
Presents measured results, voltage drop data, and example oscilloscope traces for calibration.
Outlines a procedure for checking instrument function and provides guidelines for test setup and grounding.
Highlights national/international safety recommendations and user responsibilities during testing.
Lists the standard items included with the AN 200 / AN 200B and highlights available optional accessories.
Formal declaration by the manufacturer regarding product compliance with applicable CE directives and standards.
Presents a detailed circuit schematic overview of the AN 200 and AN 200B models.
General| Category | Test Equipment |
|---|---|
| Type | Surge Generator |
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Standard | IEC 61000-4-5 |
| Pulse Types | 1.2/50 μs, 8/20 μs |
| Internal Resistance | 2 Ohm, 12 Ohm |
| Modulation | Not applicable |
