EMX IRB-4X Instruction Manual

EMX Industries, Inc. Tech support: 216-518-9889 1/4
IRB-4X_Rev2.1_062320 technical@emxinc.com
IRB-4X
™
Thru Beam Photoeye
Instruction Manual
The IRB-4X thru beam photoeye is an external entrapment protection device type B1, non-contact sensor
for use with automatic gates and doors. The photoeye provides a signal to the gate or door operator that
the beam is or is not obstructed. The IRB-4X operates up to 115 feet in a weather-proof NEMA 4X housing.
A red alignment indicator on the receiver provides status information at a glance, making set-up and
alignment easy.
This product is an accessory or part of a system. Install the IRB-4X according to
instructions from the gate or door operator manufacturer. Comply with all applicable
codes and safety regulations.
The IRB-4X is not UL compliant. This photoeye will not work with gate or door operators
that require monitored safety devices.
Ordering Information
• IRB-4X KIT Thru beam photoeye kit, includes transmitter, receiver, protective hoods,
and sunshield
• IRB-HD-SET Gold anodized aluminum protective hoods
• IRB-SH-SET Gray powder-coated steel protective hoods
Cautions and Warnings
Specifications
Operating Range
Up to 115 ft. (35 m)
Power
12-24 VDC/AC
Current Draw of Transmitter
37 mA
Current Draw of Receiver
23 mA standby, 17 mA detect
Surge Protection
Thermal fuse
Relay Output Configuration
Form C contacts (NO, COM, NC)
Relay Contact Rating
1 A at 24 VDC / 120 VAC
Operating Temperature
-40° to 170°F (-40° to 77°C)
Dimensions (L x W x H)
2.3” (57 mm) x 2.6” (65 mm) x 3.7” (94 mm)
Environmental Rating
NEMA 4X
TM

EMX IRB-4X Specifications

General

Brand	EMX
Model	IRB-4X
Category	Accessories
Language	English