- -
6
Tools selection & proper material range
Tool type Tool material Work piece material
HSS Non-iron material steel iron
End mill
TUNGSTEN CARBIDE Cast iron non-iron material
Face mill
TUNGSTEN CARBIDE Non-iron material steel iron
Light material
Drilling
HSS Non-iron material steel iron
Light material
Tapping
HSS Non-iron material steel iron
Light material
2. FEATURES
(1) This machine has, several uses, such as surface cutting, drilling, milling, and also can be
equipped with an electric switch for tapping.
(2) This machine is of fine quality, can be operated easily, and it is not limited to skilled operators.
(3) The drilling and milling operation can be performed by two methods:
1). Hand operation, which makes quick drilling.
2). Worm gear feed operation, which makes slow milling.
(4) Bronze adjustable nuts, which adjust the thread clearance and reduce the wear. They also make
screws rotated smoothly and increase the thread accuracy.
(5) Whole column which makes this machine strong, stable, and also keep the high accuracy.
(6) Head of tough cast ensures its accuracy lasting and enduring through the treatment of precise
boring cylinder, grinding, and internal stress relief.
(7) To adjust belt and change speed, new pulley cover is easy to open the cover.
3. DELIVERY & INSTALLATION
Unpacking
1. Transportation to desired location before unpacking, please use lifting jack.(Fig. B)
2. Transportation after unpacking, please use heavy duty fiber belt to lift up the machine.
ALLWAYS KEEP PROPER FOOTING & BALANCE WHILE MOVING THIS MACHINE.
To Next Page
Loading...
