Enco Control - Transportation and Storage; Switching On;Off

To Next Page

To Previous Page

ENCO Control

Technical description

•Kulautuvos g. 45a , LT-47190 Kaunas •Tel. (+370 37) 360234 •Faks. (+370 37) 360358 •info@axis.lt • www.axis.lt

(Figure 20, Figure 21).

Cabinet, where the device is mounted, must be marked with symbol № 5036 on

ISO 3864:

Danger! Risk of death from electric shock.

Environmental conditions:

- Ambient temperature from + 5 C to + 55 C,

- Relative humidity up to 93 

TRANSPORTATION AND STORAGE

 Packed equipment may be transported in any type of covered vehicle. Equipment

should be anchored reliably to avoid shock and possibility to shift inside vehicle.

Transportation temperature from -25 C to +55 C, relative humidity up to 95  at +25

C and atmospheric pressure of 84 kPa up to 106,7 kPa.

 Equipment should be protected against mechanical damage and shock.

 Equipment should be stored in dry, heated premises, where environment temperature

is not lower than +5

o. No aggressive chemical substances should be stored together

because of corrosion hazard.

SWITCHING ON/OFF

 Switch on the power (Fig. 1). The device is ready for operation.

 Device status indicates LED1 (Fig. 2): Power is on - the LED1 lights up and blinking,

power is off LED1 is not lit.

 The device switches off with the automatic switch (2-pole circuit breaker).

 Automatic switch should be installed close to device and so that it was easily available

to service personnel.

Fig.1 Connection to the mains supply

Enco Control

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

62 61 60 59 58 57 56 55 54 53 52 51 50 49 48 47 46 45 44 43 42 41 40 39 38 37

J28 J27

J21 J29

PSU 230V