15
CAUTION
If the ignition is in the “ON” position
there is potential for sparks and
engagement of components. Sparks
could cause an explosion or moving
parts could engage causing personal
injury.
Be sure ignition switch is in the “OFF”
position before charging the battery.
WARNING
Removing standard, original equipment
parts and accessories may alter the
warranty, traction, and safety of the
machine. Unauthorized changes to the
engine, fuel or venting system, may
violate EPA and CARB regulations.
SAFETY AND INSTRUCTIONAL
DECALS
• Keep all safety signs legible. Remove
all grease, dirt and debris from safety
signs and instructional labels.
• Replace all worn, damaged, or missing
safety signs.
• When replacement components are
installed, be sure that current safety
signs are affixed to the replaced
components.
• If an attachment or accessory has been
installed, make sure current safety signs
are visible.
New safety signs may be obtained from
your authorized ENCORE equipment
dealer.
• Safety signs may be affixed by peeling
off the backing to expose the adhesive
surface. Apply only to a clean, dry
surface. Smooth to remove any air
bubbles.
• Familiarize yourself with the following
safety signs and instructional labels.
They are critical to the safe operation of
your machine.
To Next Page
Loading...
Need help?
General
