EasyManuals Logo

Encore ENDSL-A2+R2 Specifications

Encore ENDSL-A2+R2
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
IP Multicast IGMP v1/v2
Supports up to 128 MAC learning addresses
IP Management
NAT (Network Address Translation) up to 1024 NAT translation sessions
NAPT (Network Address and Port Translation)
DHCP Server / Relay / Client
DNS Proxy
Dynamic DNS,
UPnP support
Security
PPP over PAP (Password Authentication Protocol; RFC1334)
PPP over CHAP (Challenge Authentication Protocol; RFC1994)
Embedded Firewall and IP filtering
Password Protected System Management
Web Based Management
Web-based GUI Configuration / Management
Command-line Interpreter (CLI) via serial interpreter or Telnet over Ethernet
Telnet Remote Management
Firmware upgrade via FTP / TFTP
Support SNMP
Built-in Diagnostic tool
Interface
One RJ45 port compatible with IEEE 802.3/802.3u, 10/100Mbps auto
selection
One USB port compliant with USB v1.1, full speed (12Mbps)
One RJ11 port for ADSL connection
One reset button for restoration of factory default setting
LED Indicators
Power, USB, ADSL, LAN, DATA
Power Requirement
Power Adapter: Input 110
±
10 or 230
±
10 VAC, Output 12VDC 600mA
Dimensions (Approximate)
125 mm (Length) x 88 mm (Width) x 27 mm (Height)

Other manuals for Encore ENDSL-A2+R2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Encore ENDSL-A2+R2 and is the answer not in the manual?

Encore ENDSL-A2+R2 Specifications

General IconGeneral
BrandEncore
ModelENDSL-A2+R2
CategoryModem
LanguageEnglish

Related product manuals