Encore ENH916P-NWY User Manual

1
FCC Warning
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limitations are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if no installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into a different outlet from that the receiver is
connected.
 Consult your local distributors or an experienced radio/TV technician for
help. Shielded interface cables must be used in order to comply with
emission limits.
 Shielded interface cables must be used in order to comply with emission
limits.
Changes or modifications to the equipment, which are not approved by the party
responsible for compliance, could affect the user’s authority to operate the
equipment.
Copyright © 2009 All Rights Reserved.
Company has an on-going policy of upgrading its products and it may be
possible that information in this document is not up-to-date. Please check with
your local distributors for the latest information. No part of this document can be
copied or reproduced in any form without written consent from the company.
Trademarks:
All trade names and trademarks are the properties of their respective
companies.
CE Declaration of conformity
This equipment complies with the requirements relating to electromagnetic
compatibility, EN 55022 class A for ITE, the essential protection requirement of
Council Directive 89/336/EEC on the approximation of the laws of the Member
States relating to electromagnetic compatibility.

Encore ENH916P-NWY Specifications

General

Standard	IEEE802.3, 10BASE-T IEEE802.3u, 100BASE-TX IEEE802.3x Full Duplex operation and Flow Control
LED indications	System Power Port Link/Activity
Emission	FCC Class A, CE, VCCI
Interface	16 * RJ-45 NWay switching ports
Cable Connections	RJ-45 (10BASE-T) : Category 3, 4, 5 UTP/STP RJ-45 (100BASE-TX) : Category 5 UTP/STP
Network Data Rate	Auto-negotiation (10Mbps, 100Mbps)
Transmission Mode	Auto-negotiation (Full-duplex, Half-duplex)
MAC Address Table	8K MAC entries
Filtering/Forwarding Rate	10Mbps: 14, 880pps/14, 880pps 100Mbps: 148, 800pps/148, 800pps
System Buffer Memory	156K Bytes
Operating Temperature	0 ~ 40 C (32 ~ 104 F) 0 0 0 0
Operating Humidity	10% - 90%
Power Supply	External linear power adapter (12V/1A)