Need help?Do you have a question about the Encore ENM232-8CMI and is the answer not in the manual?
General| Brand | Encore |
|---|---|
| Model | ENM232-8CMI |
| Category | Sound Card |
| Language | English |
Equipment tested against FCC Part 15 Class B digital device limits.
Equipment tested against European Council Directive for EMC and EN standards.
Measures to ensure reasonable protection against radio frequency interference.
Complies with PC99 requirements and supports 7.1 surround sound.
Features C3DX HRTF 3D audio, Dolby Digital EX, and DTS ES playback.
Utilizes Xear 3D™ Virtual Speaker SHIFTER and extensive EQ/effects.
Provides karaoke functionality and enhances gaming/theater audio experiences.
Requires an available PCI slot and a CD-ROM drive.
Supports Windows 8, 7, XP, and Vista.
Specifies required audio output devices for functionality.
The main product unit itself.
Contains the necessary software drivers.
Provides essential setup instructions.
Port for Left and Right Front audio speakers or headphones.
Port for Left and Right Rear audio speakers.
Port for Center & Subwoofer (LFE) audio speakers.
Port for Left and Right Back audio speakers.
Port for Audio Line-in connection.
Port for Microphone-in connection.
Port for S/PDIF digital audio output to external systems.
Ensure Windows OS is properly installed before hardware installation.
Steps include powering off, opening case, inserting card, closing case, and powering on.
Insert CD, launch setup, and click the 'Driver' button.
Click 'Run' for automatic software and driver selection.
Accept the terms of the license agreement to proceed.
Click 'Install' to start the software installation process.
Restart the computer after successful driver installation.
Verify driver status in Device Manager under Sound, video and game controllers.
Configure playback settings in the Sound control panel.
Select '7.1 Surround' for speaker configuration and test.
Open the 'PCI 3D Audio Configuration' software from the notification area.
Configure output device, audio jack, and DSP mode (e.g., 7.1 Virtual Speakers Shifter).
Configure audio output devices like headphones or speakers, including '8 Speakers' for 7.1.
Check and select audio output frequency for external sound systems via S/PDIF.
Enable 7.1 virtual speaker shifter for multi-speaker output.
Test audio output devices using the built-in speaker test function.
Select playback/recording devices and adjust volume levels.
Set up environment, environment size, and equalizer effects.
Configure microphone echo, key shifting, and vocal cancellation.
View codec and software driver version details.
To Next Page