HYDRO-DRIVE WALK BEHIND MOWER
32
TROUBLESHOOTING
IMPORTANT: It is essential that all operator safety mechanisms be connected and in proper operating condition
prior to mower use.
When a problem occurs, do not overlook the simple causes. For example, starting problems could be caused by
an empty fuel tank.
The following table lists some of the common causes of trouble. Do not attempt to service or replace major
items or any items that require special training or adjustment procedures. Have this work done by your Service
Dealer.
Engine will not start or is Hard To Start
No Fuel
Too Much Fuel (flooded)
Interlocked Controls Not Positioned Properly
Air Filter or Air Screen is Dirty
Faulty Spark Plug
Improper Fuel
Stops Suddenly or Lacks Power
No Fuel or improper Fuel
Engine Overloaded
Dirt in Fuel Line
Air Filter or Air Screen is Dirty
Incorrect Oil Level
Blocked Fuel Filter
Engine Overloaded
Dirty Air Filter or Air Screen
Dirt in Fuel Line
Blocked or dirty cooling fins
Incorrect Oil Level
Mower Pulls Left or Right
Unequal Tire Pressure
Tracking knob has been inadvertently moved
Unequal Tire Pressure
Different Quantities of Spindle and/or Caster Spacers
Blades Dull or Damaged
Belt is Broken, Worn, or Out of Adjustment
Blades Dull or Damaged
Engine Bolts are Loose
Mower moves slowly or not at all
Hydraulic pump drive belt is loose
Cold-start clutch disengaged
To Next Page
Loading...
