LOCATION OF CONTROLS
1-3) DISC 1,2,3 SELECTOR
4) CD OPEN BUTTON
5) STANDBY/ON BUTTON
6) SLEEP/TIMER BUTTON
7) X-BASS BUTTON
8) MEM/CLK-ADJ BUTTON
9) PLAY MODE BUTTON
10) PRESET UP/DOWN BUTTON
11) STOP/ST-MONO BUTTON
12) SKIP DOWN BUTTON
13) USB PORT
14) DISC SKIP BUTTON
15) STANDBY INDICATOR
16) LCD DISPLAY
17) FUNCTION BUTTON
18) REMOTE SENSOR
19) VOLUME KNOB
20) EQ BUTTON
21) PLAY/PAUSE BUTTON
22) SKIP UP BUTTON
23) HEADHONE JACK
24) AUX IN JACK
25) FM ANTENNA
26) SUB-WOOFER TERMINAL
27) SPEAKER/ TERMINAL
28) AC LINE CORD
CAUTION:
USAGE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT QUALIFIED SERVICE
PERSONNEL.
IMPORTANT:
SINCE MOVEMENT OF THE CD MECHANISM AND THE SENSITIVE CIRCUITY MAY CAUSE INTERFERENCE TO
THE RADIO TUNER NEARBY, SWITCH THIS UNIT OFF WHILE OPERATING OTHER RADIO DEVICES.
PRECAUTIONS FOR USE
INSTALLATION
• UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
• DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAINS VOLTAGE AND BEFORE
ALL OTHER CONNECTIONS HAVE BEEN MADE.
• DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF SEVERAL CENTIMETERS
AROUND THE UNIT FOR VENTILATION.
CONNECTION
1. CONNECT THE POWER CORD (28) TO AC OUTLET AND SWITCH ON THE MAIN POWER SWITCH AT THE
BACK OF UNIT.
2. WHEN YOU FIRST PLUG THE UNIT INTO THE MAINS, THE LCD DISPLAY (16) WILL LIGHT UP FOR FEW
SECONDS AND THEN ENTER STANDBY MODE.
3. CONNECT THE SPEAKER WIRE (RED TO RED/BLACK TO BLACK) TO THE SPEAKER TERMINAL (27)
LOCATED AT THE REAR SIDE OF THE UNIT. CONNECT THE SUB-WOOFER WIRE (PURPLE TO
PURPLE/BLACK TO BLACK) TO THE SUB-WOOFER TERMINAL (26) LOCATED AT THE REAR SIDE OF THE
UNIT.
4. TURN ON THE UNIT BY ON BUTTON (5). IF THE LCD DISPLAY (16) IS ON WITH BACKLIGHTING, IT MEANS
THE POWER SUPPLY IS NORMAL. NOW YOUR SYSTEM IS READY TO PLAY THE MUSIC.
SETTING THE CLOCK
1. SET UNIT IN STANDBY MODE.
2. PRESS THE “MEM/CLK-ADJ” BUTTON (8), THE FIRST DIGIT OF “00” IS FLASHING. PRESS SKIP UP
OR DOWN BUTTON (22,12) TO SET THE CORRECT HOUR (24 HOURS FORMAT).
PRESS ”MEM/CLK-ADJ” BUTTON (8) TO STORE THE CORRECT HOUR.
3. THE OTHER TWO DIGITS OF “00” IS FLASHING, PRESS THE SKIP UP
OR DOWN
BUTTON (22,12)
TO SET THE CORRECT MINUTES. PRESS “MEM/CLK-ADJ” (8) TO STORE THE CORRECT MINUTE.
THE PRE-SET TIME WILL BE RE-SET COMPLETELY IF SWITCHING OFF THE MAIN POWER
BUTTON ON SYSTEM. YOU ARE RECOMMENDED TO SWITCH THE SYSTEM INTO STANDBY
MODE FOR CONVENIENCE USAGE.
1
To Next Page
Loading...
Need help?
General