ENDEVCO 133 - SECTION 2: INSTALLATION, FRONT AND REAR PANEL DESCRIPTION AND OPERATION; 2.1 INSTALLATION AND KEY PARAMETERS

ENDEVCO www.endevco.com Tel: +1 (866) ENDEVCO [+1 (866) 363-3826]
IM133, Page
5
®
SECTION 2:
INSTALLATION, FRONT AND REAR PANEL DESCRIPTION AND OPERATION
2.1 INSTALLATION
2.1.1 UNPACKING
The Endevco Model 133 PE/ISOTRON signal conditioner is shipped along with its instruction
manual in one package. Carefully unpack and check all items for shipping damage. Report
any obvious damage to the carrier immediately. If the shipping container or cushioning
material is damaged, it should be kept until the contents of the shipment have been checked
mechanically and electrically. In any case, save the original packing materials for future
shipments of the hardware. Check each item of the shipment against the packing list. Notify
Endevco of any discrepancy.
The equipment has been inspected and tested at the factory and is ready for operation when
received.
Unpack the Model 133 and set it on a level, firmly supported surface. Verify that all standard
and ordered optional accessories are included.
2.1.2 FILTER MODULE INSTALLATION OR REPLACEMENT
For filter module installation or replacement, see Section 2.4.8 of this manual.
2.1.3 POWERING ON THE UNIT
For AC input power, install the EW599 power cord into the rear power connection of the Model
133. (See Figure 2, Rear Panel, AC input power.)
For optional DC input power (Model 133-1), install the +9-18 VDC input power source into the
DC input power connector, located on the rear of the Model 133-1. (See Figure 3, Rear Panel,
DC input power.)
2.1.4 KEY PARAMETERS
The standard unit has an AC input voltage requirement from 90 to 264 VAC, 50 to 60 Hz
(Universal Input). No jumpers or changes to the unit's power supply is required for input power
meeting this requirement.
The "-1" option is a DC powered version that accepts an input voltage range from +9 to 18
VDC.
Power dissipation for either the standard or -1 version is 9 Watts typical.
2.1.4.1 Physical Characteristics
Dimensions 5.57" x 2.52" x 12"
Weight 4 lbs typical
Case Material Black Aluminum Cover, Medium Gray Plastic Bezel
Current 1 Amp maximum