Enercell 22-135 - Heat Dispersion Management; Replacing the Inverter Fuse

7
Heat Dispersion
Thepowerinverter‘sthermalprotection
preventsitfromoperatingwhenits
temperatureexceed158°F(70°C).Ifthe
invertergetstoohotwhileworking,itwill
turnoff.Positionthepowerinverterwhere
airowsfreelyaroundittoallowtheheat
todisperse.Operationresumeswhenthe
temperaturedecreasestoabout104°F
(40°C).
Replacing the Fuse
Ifthefuseisblown,replaceitwitha20-
ampbladetypefuse(notsupplied).
1. Takeoutthefusewithpliers.
2. Insertthenewfuse.