System Setup & Connections
Enercon Industries, Ltd. Aylesbury, Bucks UK
Tel: +44 1296 330542
E-mail: info@enerconind.co.uk
Enercon Industries Corp. Menomonee Falls, WI USA
Tel: +1-262-255-6070
www.enerconind.com/sealing/support
Super Seal
TM
300/400/600 Quick Start Guide
See included diagrams and manuals for more detailed information.
Raise
Mounting
Bolts
Locking
Knob
Center Line
Label
1
Guide
Rails
1 Align sealing head and container
a. Use guide rails to ensure a consistent
container path beneath the sealing head.
b. Ensure there is no metal within 6”
of sealing head.
c. Ensure the Sealer’s height allows
containers to pass beneath the sealing head.
d. Center the sealing head over the container.
CAUTION!
The sealing head’s magnetic eld will
quickly heat any metal that enters the
eld! Keep all metal beneath the sealing
head out of the eld!
i.
2 Set the air gap over container
a. The recommended gap is 1/8” (3mm).
b. Place containers and the gapping tool
beneath the sealing head.
c. Lower the sealing head and ensure the
gap is even along it’s full length.
Lower
Flat Sealing
Head
Lower
Gap
Gauge
Tunnel Sealing
Head
Locking
Knob
2
Disconnect
Switch
Stack Light
Cable Connection
Rating
Plate
Power
Cord
iii.
ii.
3
3 Connecting and applying input voltage
a. All systems require an input voltage range
of either 200 - 240 VAC 1Ø.
Refer to your system’s rating plate.
b. If included, plug the stack light into its
connector.
c. Rotate the disconnect switch to the ON
position.
d. The front panel will display 50% factory
set point.
e. Proceed to the Basic Operation Quick
Start Guide.
Observe all safety precautions when
connecting the system to its input
voltage!
CAUTION!
i. 6mm Allen Wrench Step 1
ii. Wire Strippers Step 3
iii. Screwdriver Step 3
Required Tools:
Installation should be performed by
qualied professionals and include a
full risk assessment of the entire line.
To Next Page
Need help?
General
