To Next PageTo Next Page
Need help?Do you have a question about the ENERCON SUPER SEAL 400 and is the answer not in the manual?
Provides essential safety information and warnings for operating the equipment.
Outlines crucial safety measures and precautions for personnel and equipment.
Provides an overview of installation requirements and safety considerations for the induction cap sealer.
Provides general guidelines for safe and proper installation of system components.
Details the process for installing the system using the adjustable floor mount.
Guides assembly of the floor mount for the sealing system.
Explains how to position and secure the floor mount assembly.
Describes how to install the power supply onto the mounting yoke.
Covers aligning the sealing head for repeatable sealing results.
Details aligning container path, sealing head, and setting air gap for optimal performance.
Introduces the principles of operation and safety warnings for the sealer.
Details the steps for operating the induction cap sealer.
Instructions on how to apply input voltage to start the system.
Describes the controls and indicators on the power supply's front panel.
Explains the basic operational modes and steps for local control.
Step-by-step guide for operating the sealer in local control mode.
How to verify the output range of the power supply for different models.
Guide for configuring power supply settings and options.
How to configure the start/stop modes (Local or Remote).
How to configure the level control mode (Local or Remote).
Process for determining the optimal operating window for sealing.
How to find the minimum and maximum power levels for a good seal.
How to set the final production power level for consistent sealing.
Explains how to use remote control features for start/stop and level.
How to configure and use the remote start/stop functionality.
How to configure and use the remote level control functionality.
Overview of optional equipment and integration considerations.
Details the Automation I/O cable for various control functions.
Optional feature to stop the sealer if containers block the sealing head.
Optional feature to detect missing foil liners in caps.
Feature to stop the sealer if containers back up towards the head.
Information on the optional ejector for removing containers.
Explains how to interpret and address displayed fault codes.
General| Brand | ENERCON |
|---|---|
| Model | SUPER SEAL 400 |
| Category | Food Saver |
| Language | English |
