INSTALLATION GUIDE
Please read this document very carefully to avoid
battery monitor malfunction and/or re hazards!
Mounting CDU + Shunt
Always disconnect the battery negative cable rst before installation.
Connection diagram of single battery setup Connection diagram of a multi battery setup
¹⁾ Normally open or normally closed potential free relay contact.
Contact ratings 5A@30Vdc or 1A@70Vdc
²⁾ Battery temperature sensor is optional. Sensor kits are oered in
lengths of 3m and 10m
³⁾ Besides (future-) accessories, the additional QLINK port can also be
used to connect to a second CDU
Enerdrive ePRO Plus Battery Monitor Installation Guide (Rev. 1.2)
Always connect the battery negative cable last when the installation has been completed.
To Next Page
