EGM-PWM-LAN ENERGY METER WITH LAN INTERFACE
All brands and logos are registered trademarks of their respective owners
After a successful login you will face the Energenie page (see
section 4.2 below).
NOTE: There is a possibility that you might then need to open the
LAN settings page (see section 4.3 below) to complete the IP
configuration.
4.2. EnerGenie page
With the help of EnerGenie page (see Figure #6 below) you will be
able to see the current power consumption of the load connected, Irms,
Vrms and Energy.
The EnerGenie page also allows you to setup access of your
EGM-PWM-LAN from anywhere via Internet even if it does not have an
external IP address. To setup this free service you should follow two
simple steps:
Register the device. To restrict access to the device via the Internet
to the rightful owner only, the device should be registered – e.g.
assigned to your account. To register the device, simply push the
button Register on this page (see Figure #6 below). You will then be
redirected to Login page of EnerGenie.com. If you already own an
account at EnerGenie.com then just enter your login and password
on this page and you are done. Otherwise, use the Registration
To Next Page
Loading...
Need help?
General
