35
ENB542BDS by ENERGER
Care and maintenance
In more detail…
GB
IE
WARNING! Only perform the steps described within these
instructions! All further inspection, maintenance and repair work
must be performed by an authorised service centre or a similarly
qualified specialist if you cannot solve the problem yourself!
Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore check the product using this section.
In most cases the problem can be solved quickly.
Trouble shooting
Problem Possible cause Solution
1. Saw will not start 1.1 Loose electrical
connections
1.1 Have qualified
electrician check
electrical connections
2. Excessive blade
breakage
2.1 Material not secure
on table
2.2 Blade too coarse for
material
2.3 Teeth in contact with
workpiece before
sawing
2.4 Misaligned guides
2.5 Blade too thick for
wheel diameter
2.6 Cracking at weld
2.1 Squarely place
workpiece on table
2.2 Use finer pitch blade
2.3 Place blade in
contact with
workpiece after saw
is started and has
reached full speed
2.4 Adjust blade guides
properly
2.5 Use thinner blade
2.6 Replace blade
3. Premature blade
dulling
3.1 Blade too coarse
3.2 Inadequate feed
pressure
3.3 Hard spots or scale
in or on material
3.4 Blade installed
backwards
3.1 Use finer tooth blade
3.2 Gently increase
pressure
3.3 Reduce speed;
increase rate of feed
for scale and change
blades for hard spots
3.4 Remove blade, twist
inside out and
reinstall blade
To Next Page
Loading...