33
ENB542BDS by ENERGER
Care and maintenance
In more detail…
GB
IE
> Switch the product off and disconnect it from power supply before transporting it
anywhere.
> Protect the product from any heavy impact or strong vibrations which may occur
during transportation in vehicles.
> Secure the product to prevent it from slipping or failing over.
> We recommend using the original package for storage or covering the product
with a suitable cloth to protect it against dust.
Transportation
The blade supplied with the band saw is designed for all-purpose use. When you
select a blade you should have regarded to the following criteria:
> Use a narrow blade to cut tighter radii than you can with a wider blade.
> Wide blades are used to saw straight cuts. This is particularly important in cutting
wood because the blade has a tendency to follow the grain of the wood and
thereby deviate easily from the cutting line.
> Finely toothed blades provide smoother cuts but are slower than coarse blades.
Blade selection
IMPORTANT: Never use warped or lacerated blades!
> Move the blade guide into a position approximately half way between the table
and the machine frame.
> Undo the fixing knobs (2) and open the left side cover (3). (see fig. 30)
> Undo the two hex screws (46) and remove the blade guard (6) (see Fig. 31).
> Unscrew and remove the wing nut (29) and bolt (28) (see Fig. 1).
> Turn the blade tension knob (4) anti-clockwise to remove the tension from the
blade (23). (see Fig. 11)
> Remove the blade (23) from the upper blade pulley (5) and lower blade pulley (8),
Then take out through the slot in the table (20). (Fig. 33)
Changing the blade
To Next Page
Loading...