Why is the Energie AQUAPURA MONOBLOC 200i's power consumption abnormally high and constant?
If your Energie Water Heater is consuming an unusually high amount of power, it could be due to a leak or obstruction in the refrigerant circuit. Inspect the piping for any damage and use equipment suitable for checking leaks in the circuit.
What to do if my Energie AQUAPURA MONOBLOC 200i Water Heater has water discharge on the safety group?
If you notice water discharge on the safety group of your Energie Water Heater: * If the leak is not continuous, it may be due to the absence or incorrect sizing of the expansion vessel. Install and/or correctly dimension the expansion vessel. * If the leak is continuous, it could be due to high mains pressure. Check the reducing pressure valve (if installed) or install one if it's missing.
What to do if my Energie AQUAPURA MONOBLOC 200i Water Heater's water is too hot and/or there is steam?
If the water from your Energie Water Heater is excessively hot or producing steam, it could be due to: * A problem with the probe. Check the error display on the electronic board. * A problem with the safety thermostat. Check the correct running of safety thermostat.
What to do if my Energie AQUAPURA MONOBLOC 200i Water Heater has an electrical heater not working?
If the electrical heater in your Energie Water Heater is not working, it could be due to: * The safety thermostat being ON. Check the condition of the thermostat. * A defective electric heater. Check the electric heater.
Why is there a low hot water flow rate in my Energie AQUAPURA MONOBLOC 200i Water Heater?
A low hot water flow rate in your Energie Water Heater may be caused by a blocked hydraulic circuit. Check the condition of the hydraulic circuit.
How to fix undraining condensation in Energie AQUAPURA MONOBLOC 200i?
If you're experiencing undraining condensation in your Energie Water Heater, it could be due to: * A blocked drainage circuit. Clean the condensation circuit. * A blocked drain pipe. Check the drain pipe.
How to get rid of bad odour from Energie AQUAPURA MONOBLOC 200i Water Heater?
If you notice a bad odor coming from your Energie Water Heater, it could be due to the absence of a siphon or a siphon without water. Install a siphon and ensure it contains water.
General| Model | AQUAPURA MONOBLOC 200i |
|---|---|
| Capacity | 200 Liters |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Power | 2 kW |
| Thermal insulation | Polyurethane foam |
| Safety features | Overheat protection, pressure relief valve |
Explains symbols for danger/information and outlines pre-installation requirements.
Crucial safety guidelines for operation, installation, and maintenance.
Details of unit parts and physical measurements.
Explanation of the thermodynamic cycle and heat transfer.
Comprehensive performance metrics and specifications.
Procedures for safe handling and transportation of the unit.
General installation steps and safety devices.
Instructions for air, water, and electrical connections.
Unit placement, drain pan, and electrical system schematic.
Overview of the control panel, keys, display, and symbols.
Initial activation steps and explanation of various operating modes.
Details on TCC, Chrono scheduling, and extra modes.
Checking operation, viewing parameters, and probe data.
Identifying errors and resolving common problems.
Routine checks and emptying the water storage.
Care for magnesium anode, filters, and circuits.
Coverage periods, exclusions, and validation requirements.
To Next Page
