Welcome
Please read this manual thoroughly before installing and operating your
new Energizer® Power Inverter. This manual contains information you
need to obtain the performance required for your application. Keep this
manual for future reference.
This Energizer® Inverter converts low voltage, direct current (DC) to 110
volt modified sine wave (MSW) alternating current (AC). The inverter
draws power from 12 volt, deep-cycle batteries such as those used for
marine, golf cart, and fork-lift or from other high current 12 volt sources.
This model, ENK3000 / ENK4000, has been performance tested by MET
and complies with Underwriter’s Laboratories and Canadian Standards
Association safety standards.
A Higher Wattage Inverter May Be Required
To determine whether the Energizer® ENK3000 / ENK4000 will operate
a particular appliance or a combination of appliances, run a test. All
inverters are designed to automatically shut down in the event of a power
overload. This protection feature prevents damage to the unit while
running appliances with combined wattages below the 3000 / 4000 watt
range. Turn on the highest wattage appliance first then other appliances.
If an appliance combination in the 3000 / 4000 watt range will not
operate properly, then it is likely that this Energizer® inverter does not
have the required capacity to operate the appliance in question.
WARNINGS, CAUTIONS AND NOTES
It is very important that any operator and installer of this inverter read
and follow all WARNINGS, CAUTIONS AND NOTES and all installation
and operation instructions. In particular, comply with WARNINGS
(possibility of serious injury or death), CAUTIONS (possibility of damage
to the inverter and / or other equipment), and NOTES (included to assist
you in achieving the maximum performance and longest working life from
this advanced-design inverter).
To Next Page
Loading...
