UNIVERSAL CHARGER
INSTRUCTION MANUAL
IMPORTANT SAFETY INSTRUCTIONS:
• For Nickel Metal Hydride (NiMH) and Nickel Cadmium (NiCd) rechargeable AA, AAA, C, D
& 9V batteries only.
• Never charge NiCd and NiMH batteries together.
• Do not use to charge Alkaline, Carbon Zinc, Lithium or any other kind of battery not
specified on the charger.
• Remove the batteries from the unit once they are charged, and disconnect the charger from
the power outlet.
• For indoor use only.
OPERATING INSTRUCTIONS:
1. Connect the AC adapter’s output plug to the charger.
2. Open the safety cover by pressing the “OPEN” button. Insert batteries in the charger
respecting the polarity (+/-).
If the polarity is reversed or the batteries are not suitable for charging, the red LED will flash and
the charger will not start charging.
3. Load either:
AA/HR6/RC6 2 or 4 pieces at a
time
AAA/HR03/RC3 2 or 4 pieces at a
time
C/HR14/RC14 2 or 4 pieces at a
time
D/HR20/RC20 2 or 4 pieces at a
time
9V/HR22 1 or 2 pieces at a
time
DO NOT MIX BATTERY SIZES OR CAPACITIES IN SAME CHANNEL WHILE CHARGING.
See Pictures for how to insert the batteries into the compartments.
4. Plug the charger to a household electric outlet. The red LED will illuminate indicating that
charging is in progress.
5. When AA, AAA, C & D batteries are charged (CH1, CH2), the red LED will turn off after the
pre-set charging time is reached. The green LED will light up indicating that the trickle
charge is on. The batteries are charged and ready for use.
To Next Page
Need help?
General
