To Next PageTo Next PageWhat to do if the burner output light is ON but the burner is not running in my ENERGY KINETICS EK2 Frontier Boiler?
If the burner output light is illuminated, but the burner isn't running, you should examine the burner itself, the limit aquastat, the wiring, the burner/main circulator relay, and the burner service switch.
What to do if the burner/main circulator output light is ON but the circulator is not running in my ENERGY KINETICS Boiler?
If the burner/main circulator output light is ON, but the circulator isn't running, inspect the burner/main circulator relay, the circulator itself, and all associated wiring.
What to do if the power vent inducer light is ON but the inducer is not running in my ENERGY KINETICS EK2 Frontier Boiler?
If the power vent inducer light is ON, yet the inducer isn't running, you should check the inducer, its wiring, and the inducer relay and wiring.
What to do if the zone output light is ON but the zone valve is not open in my ENERGY KINETICS EK2 Frontier Boiler?
If the zone output light is illuminated but the zone valve remains closed, examine the zone valve and its wiring.
What to do if the bronze circulator for hot water is not running while the corresponding light is ON in my ENERGY KINETICS EK2 Frontier?
If the bronze circulator for hot water isn't running even though its corresponding light is ON, verify the hot water relay, its wiring, and the bronze circulator itself.
Why is the thermostat input light not ON in my ENERGY KINETICS Boiler?
If the thermostat input light is not ON, you should check the thermostat and its wiring.
General| Brand | ENERGY KINETICS |
|---|---|
| Model | EK2 Frontier |
| Category | Boiler |
| Language | English |
Key safety alerts and instructions for safe operation and installation.
Instructions for emergency power down and troubleshooting no heat situations.
Diagrams and details for 120VAC power supply and line voltage wiring.
Configuration of controls and crucial steps before initial boiler startup.
Step-by-step guide for safely starting the boiler and verifying operation.
Procedures to test critical safety mechanisms like high limit and relief valve.
Troubleshooting common issues by checking thermostat and zone output lights.
A quick test to verify proper function of the Energy Manager unit.
Explains error codes and troubleshooting steps for manager faults.
Steps for initial draft, CO2 tests, opening cover, and cleaning the boiler.
Procedures for checking the burner, zone valves, and safety functions during tune-up.
Details of the limited warranties for the boiler, energy manager, and pressure vessel.
