To Next PageTo Next Page
Need help?Do you have a question about the ENERVEX BEF 500x and is the answer not in the manual?
Details on how to orient the ventilator in multiple positions for installation, indoors or outdoors.
Instructions for permanently attaching the field junction box to the fan housing, minimizing water ingress and ensuring conduit flexibility.
Wiring compliance with local codes and National Electric Code (NFPA70), and requirements for EC-motors.
Information on the factory-programmed EDrive motor controller, its mounting, and disconnect switch requirements.
Guidance on mounting the EDrive motor controller in an accessible location within 300 ft of the BEFx Fan.
Detailed guidelines for connecting ground terminals, protective earth, safety ground, and motor ground for safe operation.
Instructions for connecting the motor to the EDrive E3 using appropriate cables and detailing maximum cable lengths.
Provides a typical wiring diagram for BEF 225-355x fans with 120V supply voltage to the motor drive.
Presents the wiring diagram for BEF 225-800x fans operating at 3x208-240V or 3x400-480V supply voltages.
Explanation of the EDrive keypad functions (Navigate, Up, Down, Reset/Stop, Start) for configuration and monitoring.
Step-by-step instructions for navigating and modifying parameters using the EDrive keypad.
Detailed steps for performing the Auto Tune sequence for proper start-up and configuration of the EDrive with other controllers.
General