ENFORCER ST Series - Introduction to ENFORCER Power Supplies;Chargers; Product Overview; Specifications and Components; Product Specifications Table

ENFORCER Power Supplies/Chargers
2 SECO-LARM U.S.A., Inc.
Parts List:
1x
Power Supply/Charger
2x
Wires for backup battery charger
2x
Acrylic foam tape for PCB mount
(4x for ST-2406-7AQ and ST-2406-10AQ)
1x
Manual
Introduction:
ST-1206-1.5AQ
ST-2406-2AQ
ST-2406-3AQ
ST-2406-5AQ
ST-2406-7AQ
ST-2406-10AQ
DC Voltage
6,12
6,12,24
Status
LEDs
AC Input
Green
DC Output
Red
Red/Blue (Blue indicates 24V)
Red
Current
(Continuous)
1.5A
2.0A
2.5A
4.0A
7.0A
9.0A
Current (Peak)
2.0A
3.0A
5.0A
7.5A
10.0A
Current Output
(Maximum Charge)
6V=100mA,
12V=220mA
6V=100mA, 12V=220mA, 24V=450mA
Master Fuse
3A
5A
10A
Low battery cutoff
No
When battery voltage is <20% of set ouput voltage
No
Operating
temperature
-4°~149° F (-20°~65° C)
Dimensions
2
1
/
2
"x2
3
/
4
"x1
3
/
16
"
(64x70x30mm)
2
1
/
2
"x2
3
/
4
"x1
3
/
16
"
(64x70x30mm)
2
7
/
8
"x2
7
/
8
"x1
3
/
8
"
(73x73x35mm)
2
7
/
8
"x3"x1
5
/
16
"
(73x76x33mm)
5
1
/
2
"x5
1
/
8
"x2
11
/
64
"
(140x130x55mm)
Specifications:
SECO-LARM’s ST-series of power supplies/chargers ensure that alarm systems and access control systems
have enough power to do their job. Protected by fused outputs, input polarity protection diodes, and backup
battery polarity reverse protection, these power supplies/chargers can be used to maximize the security and
efficiency of nearly any alarm or access control installation.
Wiring Diagram:
Note: The LED, DIP switch, and terminal placement may be different on other models.
ST-2406-3AQ shown
*Dual color Red/Blue LED on
ST-2406-2AQ, ST-2406-3AQ,
and ST-2406-5AQ only.
DC Output LED
(Red or Red/Blue*)
Class II
Transformer
VAC Input
Backup Battery
Alarm or Access
Control Panel
VDC Output
AC Input
LED (Green)
1 2
ON
AC
– DC +
– BAT +
Master Fuse
Voltage Selector DIP Switch